The output gas and atomization amount of the single copper head double spray gun can be adjusted.The output gas gear is used for paint drying and cleaning mold residue,and the output liquid gear is used for spraying liquid paint.The gas output and atomization volume of the spray gun can be adjusted.The gas output gear is used for paint drying and cleaning mold residue.The liquid output gear is used for spraying liquid paint.

　　Technical data:The compressed air pressure is 0.4~0.6MPa,and the e?ective lifting height of the coating is less than 4m;

 

　　Commonly used spray gun length:400mm/450mm/500mm;the length of the spray gun can be customized and multiplied by 50mm.

 

　　Nstructions for use：

 

　　1、Connect gas inlet connector A with the gas source connecting pipe and connect liquid inlet connector 0 with the liquid conveying pipe.Bundle these connectors?rmly with iron wires or hose clamps;

 

　　2、Insert the other end of the liquid conveying pipe into the open coating bucket.Note the pipe opening shall be higher than the bottom of bucket so as to avoid being blocked by residues;

 

　　3、Operation procedures:open the?rst position(gas source valve spool)for the discharge of the compressed air,and open the?rst and the second positions at the same time(liquid valve spool)for the coating spraying;

 

　　4、Gas discharge and atomization quantity may be adjusted by adjusting the gas regulating valve spool and liquid regulating valve spool.

 

　　Notes：

 

　　1、The spray gun shall be timely cleaned after the use,particularly after spraying sticky coating or coating with particles.Cleaning method:insert the coating conveying pipe into clean water(or organic solvent)for 2-3 minutes of atomization,to achieve the cleaning effect;

 

　　2、If the spray gun is blocked,you may use your thumb to block the spray nozzle,and open the?rst and the second positions at the same time,so that the blocked substances can possibly return from the coating pipe and be removed.